Automation-components ACI/Button Sensor Manuel d'utilisateur télécharger pdf (Page 2)

2305 Pleasant View Rd.  Middleton Industrial Park  Middleton, WI 53562

PH: (608) 831-2585  FAX: (608) 831-7407

I0000024.DOC Rev 4

Page 2 of 2

WALL

FIGURE 1

½” Conduit Mounting using the 1” or 2” Delrin Spacer

1. First insert the button sensor (2) wires through the top of 1” or 2” Delrin spacer. Now thread the 1” or 2”

Delrin spacer onto the back of the button sensor. Now make all of the wire connections using either crimp on

connectors or wire nuts. A small piece of foam or insulation may be inserted into the bottom of the 1” or

2”Delrin spacer to better insulate the sensor if necessary. Next insert the button sensor assembly into the ½”

conduit until it is flush to the end of the conduit as shown in Figure 2 below. You may need to tap the

button sensor assembly using a 3/8” socket and hammer for it to go into the conduit.

FIGURE 2

1/2" Conduit

If you have any further questions or comments regarding the Button sensor, please call ACI for technical assistance.





 WEEE Directive

At the end of their useful life the packaging and product should be disposed of via a suitable recycle centre. Do not dispose

of with household waste. Do not burn.

1 2

Pas de commentaire

Automation-components ACI/Button Sensor Manuel d'utilisateur Page 2